Sony KV-XA29 CRT Television User Manual


 
31Additional Information
Troubleshooting
If you find any problem while viewing your TV, please check the following guide. If
any problem persists, contact your Sony dealer .
Possible causeSymptom
Solutions
Additional Information
continued
Check the antenna cable and connection
on the TV, VCR and on the wall.
Display the CH PRESET menu and
select MANUAL PROGRAM to preset
the channel again.
Check the antenna type (VHF/UHF).
Contact a Sony dealer for advice.
Adjust the antenna direction. Contact a
Sony dealer for advice.
Try using a booster.
Turn off or disconnect the booster if it is
in use.
If the sound of all the channels are noisy,
display the CH PRESET menu and
check the TV system (TV SYS) setting,
then select AUTO PROGRAM to preset
the channels again.
If the sound of some channels are noisy,
select the channel, then display the CH
PRESET menu and select the appropriate
TV system (TV SYS).
Check the power cord, antenna and the
VCR connections.
Press
?/1
(power).
Press
!
(main power) on the TV to turn
off the TV for about five seconds, then
turn it on again.
Connection is loose or
the cable is damaged.
Channel presetting is
inappropriate or
incomplete.
The antenna type is
inappropriate.
The antenna direction
is inappropriate.
Signal transmission is
low.
Broadcast signals are
too strong.
The TV system setting
or channel presetting
is inappropriate or
incomplete.
The power cord,
antenna or VCR is not
connected.
The TV is not turned
on.
Snowy picture
Noisy sound
Distorted picture
Noisy sound
Good picture
Noisy sound
No picture
No sound
Page
4
28
27
27
4
9
9