Filter
Top Products
66
Hi DC in • Voltage of the power supply is too high (The
supplied AC power adaptor or the recommended
car battery cord is not used).
, Use the supplied AC power adaptor or the
recommended car battery cord.
HOLD • The recorder is locked.
, Slide HOLD against the arrow to unlock the
recorder (page 37).
LOW BATT • Batteries are weak.
, Charge the rechargeable battery or replace the
dry battery (page 53).
MEM OVER • You tried to record with the recorder placed where
it receives continuous vibration.
, Put the recorder on a stable place, and start
recording again.
NO COPY • You tried to make a copy from a disc that is
protected by the Serial Copy Management
System. You cannot make copies from a digitally
connected source which was itself recorded using
digital connection.
, Use analog connection instead (page 18).
NO DISC • You tried to play or record with no disc in the
recorder.
, Insert an MD.
NO SIGNAL • The recorder could not detect digital input
signals.
, Make sure that the source is connected firmly
(page 8).
P/B ONLY • You tried to record or edit on a premastered MD
(P/B stands for “playback”).
, Insert a recordable MD.
PROTECTED • You tried to record or edit on a MD with the tab in
the record-protect position.
, Slide the tab back (page 58).
Error
message
Meaning/Remedy