Filter
Top Products
Getting Started
11
Hookups
filename[010get.fm] model name1[SLV-N81] model name2[SLV-N71]
[3-065-551-11 (1)]
C Use this hookup if your TV has the Control S function (SLV-N81 only)
Notes
• To play a tape in stereo, you must use the A/V connection.
• Use the RK-G69 Control S cable (not supplied) for Control S connections.
Completing A/V hookup:
After you’ve connected your TV and completed antenna or cable hookup, return to
this procedure to complete VCR set up. This will prevent unwanted noise in the RF
channel.
Caution
Connections between the VCR’s VHF/UHF connector and the antenna terminals of the TV
receivershould bemade only asshownin thefollowing instructions. Failure to doso may result
in operation that violates the regulations of theFederal Communications Commission regarding
the use and operation of RF devices. Never connect the output of the VCR to an antenna or
make simultaneous (parallel) antenna and VCR connections at the antenna terminals of your
receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer’sattention to Article 820- 40 of the
NEC that provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of cable
entry as practical.
LINE-1
IN
LINE
OUT
IN
CONTROL S
AUDIO VIDEO
IN
VIDEO
AUDIO
AUDIO OUT
AUX IN
CONTROL S OUT
Audio/video cable
(not supplied)
TV
Audio cable (not supplied)
Stereo receiverVCR
Control S cable (not supplied)
SET :
SELECT :
OK
MENUQUIT :
TIMER SET/CHECK
SETTINGS
ADVANCED OPTIONS
SET :
SELECT :
OK
MENUQUIT :
ADVANCED OPTIONS
PAGE1
AUTO STEREO
AUTO ANT SELECT
TUNER AUDIO
TAPE SELECT
AUTO TAPE SPEED
OFF
ON
AUTO
FAVORITE CH
ON
ON
NEXT
RETURN
Press MENU andselect
ADVANCED OPTIONS.
Set AUTOANT SELECT
to OFF and press OK.
For details, see page 92.
,