Filter
Top Products
22
GB
Controlling the Volume of Visual
Components Connected to an
Audio System (continued)
1 While pressing COMMANDER
OFF, press w + and w –.
The volume control setting of visual
components (TV, VCR, CBL, SAT, and
DVD) changes to the displayed
component.
Notes
•If you have already programmed the w or
MUTING button of each component any
signals by “learning,” the procedure above
will not change the function of the w and
MUTING buttons.
•If you have programmed volume control
signals on w or MUTING buttons of TV or
AMP, you can only use that signal when you
select TV or AMP. For other component, the
preset volume control signals for TV or AMP
(depending on the above setting procedure)
will be transmitted. To use the new signals,
you need to programme each button for each
component by the learning procedure (page
15).
Executing a Series of
Commands
— System Control Functions
With the System Control function, you
can programme a series of operating
commands, and execute them by
pressing just one button.
For example, when you watch a video, a
series of operations like the ones below
are necessary.
Example:
1 Power on the TV.
2 Power on the video (VCR).
3 Power on the amplifier.
4 Set the input selector of the amplifier
to VIDEO 1.
5 Set the input mode of the TV to VIDEO
1.
6 Start video playback.
You can programme up to 32 consecutive
operation steps to each of the SYSTEM
CONTROL buttons (A – C).
If you have set the System Control
function for a Component Select button
(page 27), the execution of the
programmed commands begins when
you press the Component Select button
for more than 2 seconds.
While executing the programmed
commands, at the same time that each
remote control signal is transmitted, the
corresponding key is displayed.
When set to
amplifier volume
When set to
TV volume