Filter
Top Products
52
Setting the timer manually
To use the VCR after setting the timer
To use the VCR before a recording begins, just press ?/1. The indicator
turns off and the VCR switches on. Remember to press ?/1 to reset the VCR
to recording standby after using the VCR.
You can also do the following tasks while the VCR is recording:
• Reset the counter (page 35).
• Display tape information on the TV screen (page 38).
• Check the timer settings (page 58).
• Watch another TV programme (page 38).
To use the Auto Tape Speed function
In step 2 above, press m to select AUTO. When you are recording a
programme in the SP mode and the remaining tape length becomes shorter
than the recording time, the recording tape speed is automatically changed to
the LP mode. Note that some noise will appear on the picture when the tape
speed is changed. To operate this function correctly, the “TAPE SELECT”
setting in the USER SET menu must be accurate (see page 66).
Tips
• To set the line input video source, you can also use the INPUT SELECT button.
• Even if you set TIMER METHOD to VIDEOPLUS in the EASY OPERATION
menu, you can set the timer manually. Press MENU to select TIMER
PROGRAMMING, then go to step 2.
• To check, change, or cancel the programme setting, see “Checking/changing/
cancelling timer settings” on page 58.
Notes
• When setting the timer with PDC signals, enter the start and stop times exactly as
indicated in the TV programme guide. Otherwise, the PDC function will not work.
• If the PDC signal is too weak or the broadcasting station failed to transmit PDC
signals, the VCR will start recording at the set time without using the PDC
function.
• The and indicators flash in the display window when you press ?/1 with
no tape inserted.