Filter
Top Products
Getting Started
13
Tuning your TV to the VCR
Step 4 : Tuning your TV to the VCR
If your TV has a Scart (EURO-AV) connector, see page 15.
If your TV does not have a Scart (EURO-AV) connector
Follow the steps below so that your TV will properly receive the video signals from
your VCR.
1
Press ?/1 ON/STANDBY to turn on the VCR.
2
Press RF CHANNEL on the VCR lightly.
The currently set RF channel appears in the display window.
The VCR signal is output through this channel to the TV.
3
Turn on your TV and select a programme position for the VCR picture.
This programme position will now be referred to as the video channel.
4
Tune the TV to the same channel shown in
the VCR display window so that the
picture on the right appears clearly on the
TV screen.
Refer to your TV manual for TV tuning
instructions.
If the picture does not appear clearly, see
“To obtain a clear picture from the VCR”
below.
PROGRAM +/–
RF CHANNEL
?/1 ON/STANDBY
ON/STANDBY
AUTO
SET UP
RF CHANNEL
SONY VIDEO CASSETTE RECORDER
continued