Filter
Top Products
Additional Information
84
Specifications
Amplifier
POWER OUTPUT
Stereo Mode
DIN 1 kHz, 4 ohms, 75 W + 75 W
Surround mode
(DIN 1 kHz, 4 ohms)
Front 50 W/ch
Centre 50 W
(only in the PROLOGIC
and THEATRE mode)
Rear 50 W
Frequency response
TUNER, CD, TAPE/MD, VIDEO 1,
VIDEO 2, TV, and LINE : 10 Hz - 20
kHz ± 1 dB
Inputs
CD
Sensitivity 220 mV
Impedance 50 kilohms
S/N 82 dB
(Weighting
network, input
level)
TUNER, TAPE/MD, VIDEO1,
VIDEO2, TV, and LINE
Sensitivity 180 mV
Impedance 50 kilohms
S/N 82 dB
(Weighting
network, input
level)
Outputs
TAPE/MD REC OUT
Voltage 180 mV,
Impedance 10 kilohms
MIX OUT
Voltage : 2 V
Impedance : 10 kilohms
PHONES
Accepts low and high impedance
headphones
Muting
–20 dB
BASS BOOST
+10 dB at 70 Hz
TONE
±8 dB at 100 Hz and 10 kHz
General
Power requirements
230 V AC, 50 Hz
Power consumption
180 W
(During stand-by with the STANDBY
DISPLAY switch set to OFF)
4.6 W
Operating temperature
5°C to 40°C
Storage temperature
–20°C to 60°C
Dimensions
Approx. 430 × 157 × 430 mm (w/h/
d)
including projecting parts and
controls
Mass
Approx. 13.7 kg
Supplied accessories
Remote commander (1)
R6 (size AA) batteries (2)
Aerial cable (1)
Design and specifications are subject to
change without notice.
System
Channel coverage
PAL:
UHF E21 to E69
RF output signal
UHF channels 28 to 55
Aerial out
75-ohm asymmetrical aerial socket
VCR Inputs and outputs
VIDEO OUT (EURO-AV)
EURO LINE IN
21-pin
Video input: pin 20
Audio input: pins 2 and 6
Video output: pin 19
Audio output: pins 1 and 3
VIDEO 1 IN
VIDEO 2 INPUT
VIDEO IN, phono jack (1)
Input signal: 1 Vp-p, 75 ohms,
unbalanced, sync negative
AUDIO IN, phono jacks (2)
Input level: 327 mVrms
Input impedance: more than 47
kilohms
MONITOR VIDEO OUT
Phono jack (1)
Output signal: 1 Vp-p, 75 ohm
(unbalanced), sync negative
82 dB (’78 IHF)
(A, 0.5 V)
82 dB (’78 IHF)
(A, 0.5 V)