Filter
Top Products
49
Troubleshooting
Additional Information
Recording
No TV programme
appears on the TV
screen.
• Make sure the TV is set to the video channel. If you are
using a monitor, set it to video input.
• Existing broadcasts may interfere with the VCR. Reset the
RF channel output of your VCR.
• Select the correct source with the INPUT SELECT button.
Select a programme position when recording TV
programmes; select a line input when recording from other
equipment.
TV reception is poor. • Make sure the aerial cable is connected securely.
• Adjust the TV aerial.
The tape starts playing as
soon as it is inserted.
• The safety tab has been removed. To record on this tape,
cover the tab hole (see page 30).
The tape is ejected when
you press z REC.
• The safety tab has been removed. To record on this tape,
cover the tab hole (see page 30).
Nothing happens when
you press z REC.
• Make sure the tape is not at its end.
Timer recording
The timer does not
operate.
• Check that the clock is set.
• Make sure a tape has been inserted.
• Check that the safety tab has not been removed.
• Make sure the tape is not at its end.
• Make sure a programme has been set for timer recording.
• Make sure your timer settings are past the current time.
• The clock stops if the VCR is disconnected from the mains
for more than one hour. Reset the clock and timer.
• Turn the power off and unplug the mains lead.
The VIDEOPLUS menu
or the TIMER menu does
not appear.
• Check that TIMER METHOD in the USER SET menu is
set correctly (see page 45).
The VPS/PDC function
does not operate
properly.
• Check that the clock and the date are set correctly.
• Check that the VPS/PDC time you set is the correct one
(there might be a mistake in the TV programme guide). If
the broadcast you wanted to record did not send the good
VPS/PDC information, the VCR will not start recording.
• If the reception is poor, the VPS/PDC signal might be
altered and the VCR might not start recording.
Symptom Remedy
continued