Filter
Top Products
Getting Started
31
Setting the Set-Top Box
Notes
• If your VCR is connected to the STB by the aerial cable, enter the programme
number of the VCR corresponding to the channel where you have set up the STB
output in step 4.
• You cannot watch programmes from your STB on the TV while recording unless
you record a programme from your STB.
• It is recommended to connect your STB to the DECODER/LINE-3 IN connector.
• For some STB, in order to avoid any conflict between the STB controller and the
VCR remote commander, be careful not to point the remote commander towards
the STB and the VCR at the same time.
• If POWER SAVE is set to FULL, you cannot watch or record programmes from
your STB during standby mode. Set POWER SAVE in the OPTIONS-2 menu to
OFF or PARTIAL.
4
• If you connect the STB using the
aerial cable:
Press M/m/, to select RF and
press OK.
Press M/m to highlight
PROGRAMME NO. and press
OK. Enter the appropriate number
using M/m and press OK.
• If you connect the STB using the
Scart (EURO-AV) cable:
Press M/m/, to select LINE3 and
press OK.
5
Press M/m to highlight STB BRAND
NO. and press OK. Enter the
appropriate number using the
programme number buttons, then
press OK. Refer to the table on page
32 for Set-Top Box brand number.
Press MENU to exit the menu.
OK
PLAY
SET :
SELECT :
OK
MENUEXIT :
SET-TOP BOX
RF
---
06
STB CONNECTION
STB BRAND NO.
PROGRAMME NO.
RETURN
SET :
SELECT :
OK
MENUEXIT :
SET-TOP BOX
LINE3
---
STB CONNECTION
STB BRAND NO.
RETURN
MENU
OK
PLAY
123
456
789
0
SET :
SELECT :
OK
MENUEXIT :
SET-TOP BOX
RF
123
06
STB CONNECTION
STB BRAND NO.
PROGRAMME NO.
RETURN
continued