Settings and Adjustments
59
xDOWNMIX (DVD only)
Switches the mixing down methods when
you play a DVD on which rear signal
components such as LS, RS, or S are
recorded in Dolby Digital format. For details
on the rear signal components, see
“Changing the Sound” (page 42). This
function affects the output of the following
jacks:
— LINE OUT L/R (AUDIO) 1/2 jacks
— DIGITAL OUT (OPTICAL and
COAXIAL) jacks when “DOLBY
DIGITAL” is set to “D-PCM” in
“DIGITAL OUT” (page 59).
xDIGITAL OUT
Selects if audio signals are output via the
DIGITAL OUT (OPTICAL and COAXIAL)
jacks.
Switches the method of outputting audio
signals when you connect the following
component using a digital cord via the
DIGITAL OUT (OPTICAL or COAXIAL)
jacks.
— Amplifier (receiver) with digital input
jack
— Amplifier (receiver) with a built-in DTS,
or DOLBY DIGITAL decoder
— MD or DAT deck
For connection details, see page 19.
Select “DOLBY DIGITAL,” and “DTS”
after setting “DIGITAL OUT” to “ON.”
xDOLBY DIGITAL
Selects the Dolby Digital signals output via
the DIGITAL OUT (OPTICAL and
COAXIAL) jacks.
STANDARD Normally, select this position
TV MODE Makes the low sounds clear
even if you turn the volume
down. It is especially
recommended when you listen
to the sound using the speakers
of the TV.
WIDE
RANGE
Gives you the feeling of being at
a live performance. When you
use high quality speakers, it is
even more effective.
DOLBY
SUR-
ROUND
Select this when the player is
connected to an audio component
that conforms to Dolby Surround
(Pro Logic). The output signals
which reproduce the Dolby
Surround effect are downmixed to
2 channels.
NORMAL Select this when the player is
connected to an audio component
that does not conform to Dolby
Surround (Pro Logic). All of the
output signals are downmixed to 2
channels without the Dolby
Surround (Pro Logic) effect.
ON Normally, select this position. When
you select “ON,” set “DOLBY
DIGITAL,” and “DTS.” For details on
setting these items, see “Setting the
digital output signal.”
OFF The player does not output the audio
signals via the DIGITAL OUT
(OPTICAL and COAXIAL) jacks. The
influence of the digital circuit upon the
analog circuit is minimal.
Setting the digital output signal
AUDIO SETUP
AUDIO ATT:
AUDIO DRC:
DIGITAL OUT:
DOLBY DIGITAL:
DTS:
OFF
STANDARD
ON
DOWNMIX:
DOLBY SURROUND
D-PCM
OFF
continued