Filter
Top Products
Additional Information
61
Additional Information
Troubleshooting
If you experience any of the following
difficulties while using the CD/DVD player,
use this troubleshooting guide to help remedy
the problem before requesting repairs.
Should any problem persist, consult your
nearest Sony dealer.
The power is not turned on.
, Check that the AC power cord is connected
securely.
There is no picture.
, The connecting cords are not connected
securely.
, The connecting cords are damaged.
, The CD/DVD player is not connected to the
correct TV input
jack (page 17).
, The video input on the TV is not set so that you
can view pictures from the CD/DVD player.
Picture noise appears.
, The disc is dirty or flawed.
, If the picture output from your CD/DVD
player goes through your VCR to get to your
TV, the copy-protection signal applied to
some DVD programs could affect picture
quality. If you still experience problems even
when you connect your CD/DVD player
directly to your TV, please try connecting your
CD/DVD player to your TV’s S video input
(page 17).
Even though you set the aspect ratio
in “TV TYPE” of “SCREEN SETUP,”
the picture does not fill the screen.
, The aspect ratio of the disc is fixed on your
DVD.
There is no sound.
, The connecting cord is not connected securely.
, The connecting cord is damaged.
, The CD/DVD player is connected to the
wrong input connector on the amplifier
(receiver) (page 21, 22, 23).
, The amplifier (receiver) input was not
changed so that you can listen to the CD/DVD
player.
, The CD/DVD player is in pause mode or in
Slow-motion Play mode.
, The CD/DVD player is in fast forward or fast
reverse mode.
, If the audio signal does not come through the
DIGITAL OUT (OPTICAL and COAXIAL)
jacks, check the audio settings (page 58).
Sound is noisy.
, The disc is dirty or flawed.
, When playing a CD with DTS sound tracks,
noise will come from the LINE OUT L/R
(AUDIO) 1/2 jacks (page 29).
Sound distortion occurs.
, Set “AUDIO ATT” in “AUDIO SETUP” to
“ON” (page 58).
The remote does not function.
, There are obstacles between the remote and
the CD/DVD player.
, The distance between the remote and the CD/
DVD player is too far.
, The remote is not pointed at the remote sensor
on the CD/DVD player.
, The batteries in the remote are weak.
Power
Picture
Sound
Operation
continued