Filter
Top Products
36
Setup
Satellite Receiver To connect a satellite receiver
1 Connect the satellite antenna cable to the satellite receiver’s satellite
input jack.
2 Use an A/V cable to connect the satellite receiver’s A/V output jacks to
the TV’s A/V input jacks (VIDEO 1 or 3).
3 Connect the 75-ohm coaxial cable (not supplied) from your cable or
antenna to the TV’s CABLE or VHF/UHF input jack.
4 Run the Auto Setup program, as described in “Setting Up the Channel
List” on page 53.
Using S VIDEO jacks? See page 29.
VHF/UHF
CABLE
R-AUDIO -L
VIDEO
VIDEO IN
1
3
(
MONO
)
S
VIDEO
S
VIDEO
Rear of TV
A/V cable
Satellite Receiver
CATV
cable
75-ohm
coaxial
cable
Satellite
antenna
cable