Filter
Top Products
27
Connecting and Setting the TV
VHF/UHF
VIDEO IN
VIDEO
1
S VIDEO
(
MONO
)
AUDIO
R
L
VIDEO (yellow)
AUDIO-L (white)
AUDIO-R (red)
S VIDEO
Rear of TV
75-ohm coaxial
cable (supplied)
S VIDEO cable
(not supplied)
A/V cable (not supplied)
Satellite
antenna
cable
Satellite Receiver
Connecting a Satellite Receiver
Disconnect all power sources before making any connections.
1 Connect the satellite antenna cable to the satellite receiver’s SATELLITE
IN jack.
2 Using A/V and S VIDEO cables, connect the satellite receiver’s AUDIO and
S VIDEO OUT jacks to the TV’s AUDIO and S VIDEO IN jacks (VIDEO
1 IN or VIDEO 2 IN).
Tip
If your satellite receiver is not equipped with S VIDEO, use a VIDEO cable (yellow)
instead of the S VIDEO cable.
3 Connect the supplied 75-ohm coaxial cable from your cable box or antenna
to the TV’s VHF/UHF jack.
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make
sure “Auto YC” in the (Setup) menu is set to “On” to view the S VIDEO input (see page
26).
Tip
Use VIDEO 1/2 on the remote control to select VIDEO 1 IN (or VIDEO 2 IN if you use the
VIDEO 2 IN jacks for this hookup) to watch satellite TV.