Filter
Top Products
17
Installing and Connecting the TV
Connecting a DVD Player with A/V Connectors
Use this hookup if:
• Your DVD player does not have component (Y, P
B, PR) jacks.
Tip
If your DVD player has component video output connectors, for best picture quality, use the
connection described on page 16.
Disconnect all power sources before making any connections.
1 Using an AUDIO cable, connect the DVD player’s AUDIO OUT jacks to
the TV’s AUDIO IN jacks.
2 Using an S VIDEO cable, connect the DVD player’s S VIDEO OUT jack
to the TV’s S VIDEO IN jack.
Tip
• If your DVD player is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of
the S VIDEO cable.
Note
When you connect video equipment to both the VIDEO and the S VIDEO input jacks, make
sure “Auto YC” in the (Setup) menu is set to “On” to view the S VIDEO input (see page
12).
Tips
• You can also use the VIDEO 2 IN jacks located on the left side of the TV to connect your
DVD player.
• To take advantage of the Wide Screen Modes, set the aspect ratio of the output signal to
16:9 on your DVD player. For details, refer to the operating instructions supplied with your
DVD player.
• Use TV/VIDEO on the remote control to switch to the DVD player input.
S VIDEO cable
(not supplied)
DVD player
AUDIO cable
(not supplied)
Rear of TV
S VIDEO
AUDIO-R
(red)
AUDIO-L
(white)
VIDEO (yellow)