Sony KP 61S70 Projection Television User Manual


 
46
The picture turns off and the
TIMER/STAND BY indicator on the
front panel flashes (self-diagnosis
function)
No picture (screen not lit), no
sound
Remote control does not
operate
Dark, poor or no picture
(screen lit), good sound
Good picture, no sound
Troubleshooting
The projection TV is equipped with a self-diagnosis function. If there is a problem with your projection TV, the TIMER/STAND BY indicator on the front
panel will flash repeatedly. Counting the number of flashes helps you inform qualified Sony personnel of the projection TV’s condition.
Press POWER on the projection TV to turn it off, then inform qualified Sony personnel or the above Direct Response Center of the number of flashes.
Make sure the power cord is plugged in.
Operate with the buttons on both the projection TV and the remote control.
Check to see if the TV/VIDEO setting is correct: when watching TV, set to TV, and when watching video tapes, set to VIDEO 1, 2, or 3.
Try another channel.
It could be station trouble.
Perform AUTO SET UP again using the SET UP button to return to the factory preset condition. (see “To perform AUTO SET UP again” on page 15)
The Parental Control feature is activated. (see “To deactivate the Parental Control feature” on page 33)
Batteries could be weak. Replace the batteries.
Press TV (FUNCTION) when operating your projection TV.
Make sure the projection TV’s power cord is connected securely to the wall outlet.
Locate the projection TV at least 3-4 feet away from fluorescent lights.
Check the polarity of the batteries.
Adjust “Picture” in the Video menu. (see “Picture Adjustment” on page 22)
Adjust “Brightness” in the Video menu. (see “Picture Adjustment” on page 22)
Check antenna/cable connections.
Perform AUTO SET UP again using the SET UP button to return to the factory preset condition. (see “To perform AUTO SET UP again” on page 15)
Adjust the convergence again using the FLASH FOCUS button. (see “Adjusting the Convergence Automatically (FLASH FOCUS)” on page 15)
Press MUTING so that “Muting” disappears from the screen. (see “MUTING” on page 16)
Check the MTS/SAP setting in the Audio menu. (see “MTS/SAP” on page 23)
Make sure “Speaker” is set to “On” in the Audio menu. (see “Speaker” on page 24)
Perform AUTO SET UP again using the SET UP button to return to the factory preset condition. (see “To perform AUTO SET UP again” on page 15)
If, after reading the following instructions, you have additional questions related to the use of your Sony projection TV, please call one of the following
numbers (English only).
Customers in the continental United States contact the Direct Response Center at: 1-800-222-SONY (7669)
Customers in Canada contact the Customer Relations Center at: (416) 499-SONY (7669)