Filter
Top Products
Instruction Manual
9
6.3 Erase Master
This function is used to set if erasing the source HDD or not. Please make sure this
setting before you execute erase function.
6.4 Unknown Format
This function allows you to set how the device manages unknown HDD area.
6.5 Transfer Rate
This function allows you to select the best transfer rate from UDMA 2 to UDMA 4 for
your HDD duplication progress. If you are not condent on the HDD quality or you nd
a high failure rate on copy or compare. It is recommended to slow down the UDMA
mode.
6.6 Erase Pattern
This setting is used to select dierent erase methods.
6.7 Language
This setting is to set the system’s language interface.
6.8 Stop Motor Time
When the system nishes function executing, the motor won’t stop running
immediately. This function is used to set the time of motor stopping after nishing
function executing.
6.9 Advanced Setup
From Advanced Setup you can adjust HDD Wait Time, and lock the keys, see details
below.
a) Select “6.9 Advanced setup” using the navigation buttons.
b) From the “Advanced” menu you can select your desired application See the list
below outlining the details of each option.
Note: The number 6.9 at the beginning of each option below represents the
“Advanced Setup” heading on the main menu, the numbers: .1, .2, .3, etc. indicate
the option within the “Advanced Setup” sub menu.
6.9.1 Wait HDD Time
This is to set auto start time after plugging in HDD.
6.9.2 Lock Key
After this function is selected, only OK and ESC keys are working.
6.10 Restore Default
This setting is to go back to the manufacturer’s default setting.