Filter
Top Products
Instruction Manual
3
3. Using an included SATA Cable, connect up to 3 HDDs you would like to have over
written, or erased to the destination ports. (3 ports from right to left , see below
WARNING! Any Data remaining on the destination drives will be over written.
Note: If using less than 3 HDDs, drives should be connected from left to right
leaving port(s) closest to the right unoccupied.
4. Press the power switch to the “On” position, the SATDUP13 is now ready to use.
Hardware Installation
1. Ensure the power switch is set in the o position. Connect the included power
adapter from an available AC power outlet to the Power Adapter Port on the back
of the SATDUP13.
2. Using an included SATA Cable, attach the HDD you would like to duplicate to the
source port (rst port on the left, see below)