Filter
Top Products
Instruction Manual
4
Hardware Operation
Hard Drive Duplication
1. Using the Navigation buttons, locate “HDD Duplicator 1. Copy” and press OK. Default
copy mode is “System and Files”. To change Copy mode please see “Setup section”.
2. The duplicator will analyze the source drive and ensure all the targets are ready,
by verifying size. Once the drives have been analyzed you will receive an indicator
stating the duplicator is ready. Press OK, and the system will begin duplication
automatically.
3. Duplication will complete when the % indicator reaches 100%. The destination
drives now contain identical data to the source drive.
Note: If the destination drives are larger than the source drive, a single partition the
size of the source drive will be on the destination drive.