Filter
Top Products
Instruction Manual
3
Hardware Installation
1. Connect an HDMI video cable from the HDMI out port on the Wireless Video
Adapter to the HDMI in port on the HDMI enabled display device.
2. Connect the power adapter from an available AC outlet to the power adapter port
on the Wireless Video Adapter.
or
Connect the USB to power cable from an available USB power source to the power
adapter port on the Wireless Video Adapter.
3. Press the Power button to the in position to turn on the device, the Power LED will
be activated.
4. (Optional) If you intend to use the device for Screen sharing over a wired LAN
Network, connect an Ethernet cable from the RJ45 LAN port on the Rear of the
WIFI2HDMC, to an available LAN port on your local network gateway device
(router/hub).
5. (Optional) If you intend to output to an analog audio or video source, connect
the included “4 Position A/V cable” from the Analog Audio/Video out port to
Component video/RCA Audio input source on your analog audio or video device.
Note: Analog output will only work with the included 4 Position A/V cable. Analog
Audio/Video is not supported in Miracast mode.