Filter
Top Products
5-2 Sun Fire™ B1600 Chassis and B100s, B100x, and B200x Blade Product Notes • May 2004
5.1 Upgrading the System Controller (SC)
Firmware
To support Sun Fire B200x blades in a Sun Fire B1600 blade system chassis, you must
be running System Controller firmware version 1.2. To perform the upgrade of the
System Controller firmware, follow the instructions in the Sun Fire B1600 Blade
System Chassis Administration Guide (Chapter 10).
5.2 What To Do If You Lose Your Password
for the System Controller
There is a method described in Chapter 9 of the Sun Fire B1600 Blade System Chassis
Administration Guide (on the Documentation CD) for regaining access to the System
Controller if you have forgotten your password.
Note – It is possible that the method described on the CD you have received is
incorrect.
If you lose your password to the System Controller, the correct procedure for
regaining access to the device is as follows:
1. Remove and then re-insert one of the power supplies.
2. Within five minutes of re-inserting the power supply, set up a serial connection to
the SSC containing the active System Controller and log in as user admin.
For information about setting up a serial connection to the SSC, see the Sun Fire
B1600 Blade System Chassis Hardware Installation Guide.
To log in, type the default user name admin and when prompted for a password,
press [ENTER].:
username: admin
password: [ENTER]