Filter
Top Products
SunBriteTV Model 4660HD Operator’s Manual
Page 3
Cleaning Instructions: Use a soft cloth with mild detergent in warm water to clean the SunBriteTV screen. Remove any dirt and salt
deposits from the unit, being careful to rinse the cloth frequently to avoid scratching the screen surface. Avoid using harsh chemicals,
ammonia, abrasives, or solvents when cleaning any surface on the screen. When the TV is not in use, it is important to keep it covered
with the SunBriteTV tted Outdoor Dust Cover. Use a soft brush or towel to remove snow and ice from the TV. In areas where dust or salt
air is prevalent, it is recommended that the ber lter be cleaned regularly (see instructions on Page 42).
Attachments: Do not use attachments not specically recommended by the manufacturer. Use of improper attachments can result in
accidents.
Power Source: SunBriteTV must operate on a power source indicated on the specication label. If you are not sure of the type of power
supply used in your home, consult your dealer or local power company. When using the TV outdoors, you must use a GFI-protected AC
outlet with “in-use” waterproof cover.
Installation: Do not place the product on an unstable cart, stand, tripod, table, or anywhere the unit is not permanently installed. Placing
the product on an unstable place can cause the product to fall, resulting in potential serious personal injuries, as well as damage to the
product.
Precautions when Transporting the TV: Carrying the television requires at least two people.
FCC Statement
This equipment complies with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment
o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and
receiver.
3. Connect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV
technician for help.
Modications not expressly approved by the
manufacturer could void the user’s authority to operate
the equipment under FCC rules. This device complies
with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired
operation.
Important Safety Instructions