Filter
Top Products
Page 40
Appendix A - RS232 Control Cable Pinout
IR Emitter Installation
To install the IR Emitter:
The photo to the right shows an IR Emitter* installed.
The end of the Emitter is to be mounted in front of
the IR Emitter Window.
Place the emitter on the white tie-down block and
use the tie-down to secure it in place.
Place the emitter cable over the right or left side
of the cable box and connect the other end of the
emitter to the appropriate control block*.
* Neither the emitter or control block are supplied by
SunBriteTV. See instructions that come with your IR
Emitter and control block to determine how to make the
connections.
Tie-Down Block
Tie-Down
IR Emitter
Place IR Emitter Cable
over right or left side of
the cable box.
IR Window