Filter
Top Products
5-4
SUPERSERVER 5017P-TLN4F/TF User's Manual
5-4 Onboard Processor and Heatsink
The X9SPV-LN4F/F-3610ME features an embedded Intel Core i7 Mobile ECC
processor with an FCBGA 1023 package.
5-5 Installing Memory
Caution! Exercise extreme care when installing or removing DIMM modules to
prevent any possible damage.
Note: Check the Supermicro website for a list of memory modules that have been
validated with the X9SPV-LN4F/F-3610ME motherboard.
How to Install SO DIMMs
1. Insert the desired number of SO DIMMs into the memory slots, starting with
DIMMA1, then DIMMB1. Pay attention to the notch along the bottom of the
module to prevent incorrect DIMM module installation.
2. Insert each SO DIMM module vertically and snap it into place. Repeat step 1
to install DIMMB1 if needed. See instructions on the next page.
Memory Support
The X9SPV-LN4F/F-3610ME motherboard supports up to 16GB of DDR3 ECC
SODIMMs (1333/1066/800 MHz in 2 SODIMM slots).
5-6 Adding PCI Add-On Cards
The 5017P-TLN4F/TF can accommodate a single full-height, half-length add-on
(expansion) card.
Installing an Add-on Card
1. Begin by removing the shield for the PCI slot where the riser card is located.
2. Fully seat the card into the riser card, pushing down with your thumbs evenly
on both sides of the card.
3. Finish by using a screw to secure the top of the card shield to the chassis.
The PCI slot shields protect the motherboard and its components from EMI
and aid in proper ventilation, so make sure there is always a shield covering
each unused slot.