Filter
Top Products
5-22
SUPERSERVER 6014P-8/6014P-8R/6014P-82R/6014P-82 User's Manual
Watch Dog
JWD1 controls Watch Dog, a sys-
tem monitor that takes action
when a software application
freezes the system. Jumping pins
1-2 will cause WD to reset the
system if an application is hung
up. Jumping pins 2-3 will generate
a non-maskable interrupt signal for
the application that is hung up.
See the table on the right for
jumper settings. Watch Dog can
also be enabled via BIOS.
Note: When enabled, the user
needs to write his own application
software in order to disable the
Watch Dog Timer.
Jumper
Position
Pins 1-2
Pins 2-3
Open
Definition
WD to Reset
WD to NMI
Disabled
Watch Dog
Jumper Settings (JWD1)
Memory Speed Select
(X6DHP-8G only)
Use XJ4F1 and XJ4F2 to select the
speed of the system memory. See
the table on the right for jumper
definitions. The default setting is
closed (DDR333).
Note: if these jumpers are not set
correctly, you may experience
problems with your video display.
Memory Speed Select
Jumper Settings
(XJ4F1, XJ4F2)
XJ4F1
Closed
Open
XJ4F2
Closed
Open
Memory Speed
333 MHz
(DDR333)
266 MHz
(DDR266)