Filter
Top Products
52
Problem: If the DVD 1235 R is connected to a TV
set directly using a SCART lead, this
can result in a scrolling DVD picture
appearing on all programme memories.
This problem may occur with many
types of TV.
Cause:
The TV set is analysing the A/V switching
signal from the DVD player incorrectly, or
not at all.
Remedy 1:
If possible, call up the Setup menu for
your TV set and switch off RGB priority.
Select the RGB signal type for the DVD
SCART input of your TV set.
Remedy 2:
If your television does not provide this
option, connect the DVD player using an
S-VHS lead, or use a SCART lead without
RGB signal. Ask your dealer for help
with this.
Remedy 3:
When watching TV, switch off the DVD
player by pressing the
button on
the front panel.
Problem:
When used in a non- system the
machine does not respond to remote
control commands, or cannot be
switched on by remote control.
Cause: E 2000 remote control receiver not con-
nected.
Remedy: Connect the E 2000 remote control
receiver as shown in Wiring Diagram 3.
Press the source select button
(or
) on the remote control handset
to switch the machine on.
Problem:
When operating the menu for the surround
decoder or surround receiver, the
DVD 1235 R also responds.
Cause: E 2000 connected to the DVD 1235 R.
Remedy: Connect the E 2000 to the pre-amplifier,
integrated amplifier or receiver.
Problem: MP3 CD does not play back.
Cause:
MP3 format not supported
(see 'Playing MP3 CDs').
Remedy: (see 'Playing MP3 CDs')
Problem: Distorted or double picture at the YUV
output (only P-Scan option)
Cause:
P-Scan switched on buit TV set not
compatible with progressive video signals
Remedy:
Switch P-Scan off (
button on the
front panel).
Problem: No picture.
Cause:
Video-output switched off
Remedy:
switch ON the video output (
button on the front panel)
Problem:
'
overheat
overheatoverheat
overheat
' displayed, playback stopped
Cause:
Device is over heated, too little flow of
cooling air
Remedy:
change the installation of your system to
provide sufficient cooling.
do not place the DVD 1235 R on top of hot
equipment like amplifiers or surround
receivers
Problem: Discs can not be played. A message to
enter a PIN appears.
Cause:
This disc is locked
Remedy:
Enter a valid PIN number or unlock the
disc (see menu 'Setup / Access').
Note:
In case you have forgotten your PIN
number, enter the menu 'Setup / Access /
Enter PIN'. Enter the input box on the
right and press the
-button four
times (the on screen display will show the
“forbidden” icon). Then enter 0000 twice.
The PIN is now reset to to 0000.