Filter
Top Products
PAGE 12/22
119077.01 TELEPRESENCE T3 ROOM INSTALLATION GUIDE 12.08
TANDBE RG
Telepresence T3
6. The profiles shall fit as shown to the left.
Should you need to adjust the length of any of the panels, it is important to
use the right tools.
Note! Be sure to cut the panels with the backside up, in order to minimize
the risk of damaging the front of the panels. Observe how dimensions are
presented (page 6 of this document)
7. The profile D is to be used at the top of the topmost panel. Fasten with
screws to the top lattice.
The top panel with profile D as seen from the back is shown to the left.
8. Insert black aluminum trim pieces vertically between adjacent panels.
These are not precut and must be cut to fit from aluminum stock.
RO OM IN S TA LLATION G U ID E
ThE WOO DEN PA NEL S
How the profiles should fit.
The top panel with profile D as seen from
the back
Back of Wood Panel upwards
Saw for Gypsum
with guide rail
Integrated dust extraction
Aluminum Profile
Saw for Gypsum
with guide rail
Integrated dust extraction