Filter
Top Products
Yellow bar: good reception
Green bar: excellent reception
6 Operation
At the first time the receiver the receiver gets connected to the main supply the display
shows successively the symbols dL, Iu and rA. During this time the receiver checks if a
new operation software is available at the serial interface. If a new software is available the
receiver gets updated.
6.1 Switching on and off
> Use the key On/standby on the receiver or on the remote control to switch the
receiver on.
> Pressing the same key on the receiver or on the remote control again will switch the
receiver off again.
While the display shows ird, the receiver checks the last activated transponder if
there is a new irdeto software available.
> After this procedure the receiver is in standby mode.
6.2 Programme Selection
6.2.1 Using the Programme up/down keys
> Use the Channel up/down keys either on the receiver front panel or on the remote
control to move up or down the list one channel at a time.
6.2.2 Using the Numeric Key Pad
> Use the numeric key pad to enter the desired programme/channel number directly:
For example:
1 Programme/channel 1
1, followed by 4 Programme/channel 14
2,followed by 3, followed by 4 Programme/channel 234
When entering programme numbers consisting of more than one digit, you have about 3
seconds after pressing one digit to enter the next digit, in order to complete the entry in such
a way that the receiver recognises all digits as part of one selection.
If you are entering a programme number with only one or two digits, you can speed up the
selection process by pressing OK after entering the last digit.
6.2.3 Using the Programme List
> Press the key OK
A list of programmes will now be displayed.
18
bed_anl_DigiBox Irdeto_englisch.qxd 30.01.02 12:03 Seite 18