Technicolor - Thomson AV2 Flat Panel Television User Manual


 
3
20.Stand—Do not place the product on an unstable
trolley, stand, tripod or table. Placing the product on an
unstable base can cause the product to fall, resulting in
serious personal injuries as well as damage to the product.
Use only a trolley, stand, tripod, and bracket or table
recommended by the manufacturer or sold with the
product. When mounting the product on a wall, be sure
to follow the manufacturer’s instructions.
Use only the mounting hardware recommended by the
manufacturer.
21.Careful move— When relocating the product
placed on a trolley, it must be moved with the utmost
care. Sudden stops, excessive force and uneven floor
surfaces can cause the product to fall from the trolley.
22.Panel protection—The LCD panel used in this
product is made of glass.
Therefore, it can break when the product is dropped or
impacted upon by other objects. Be careful not to be
injured by broken glass pieces in case the LCD panel
breaks.
On some models, the screen is protected by a glass shield.
Under certain conditions (changes of temperature and
humidity) moisture may form between the glass and the
screen.
If this relatively rare condition arises, it is only necessary to
switch on the LCD TV for around twenty minutes, to make it
disappear.
23.Pixel defect—The LCD panel is a very high technology product, giving you finely detailed pictures.
Occasionally, a few non-active pixels may appear on the screen as a fixed point of blue, green or red.
Please note that this does not affect the performance of your product.
For added protection for this television equipment during
a lightning storm, or when it is left unattended and unused
for long periods of time, unplug it from the wall outlet and
disconnect the antenna. This will prevent damage to the
equipment due to lightning and power-line surges.
An outside antenna system should not be located in the
vicinity of overhead power lines or other electric light or
power circuits, or where it can collide with such power
lines or circuits. When installing an outside antenna
system, extreme care should be taken to keep from
touching such power lines or circuits, as contact with
them might be fatal.