Filter
Top Products
Menus
31
EN
EN
Speakers
This function is provided for adjusting the bandwidth of the six 5.1 outputs according to the
loudspeakers actually connected to the amplifier.
1. From the player menu,highlight Speakers and
validate by pressing OK.
2. Select Front, Center,Subwoofer,Surround using
the or key and validate by pressing OK.
3. Select the size of your loudspeakers (or select None
if you do not have the loudspeaker(s) concerned)
using the or key and validate by pressing OK.
Note : selection of Small is intended for small loudspeakers
which cannot correctly reproduce low frequencies.In such case
the low frequencies are fed into the subwoofer.
Note : certain unsuitable choices are “rejected”by your player
which interprets your intention and suggests an optimised
configuration.
Distance
This function is used to specify the distance between the various loudspeakers and the listener.
1. From the player's menu,highlight Distance and
validate by pressing OK.
2. Select Front, Center,Surround using the or
key and validate by pressing OK.
3. Adjust the distance using the or key and
validate by pressing OK.
Test
This function is used to adjust the volume level of the various loudspeakers in order to compensate
for their differences in acoustic efficiency. Switch on your amplifier and adjust the volume to a sufficient
level to be able to hear the test signal generated by your DVD player.Then sit in the position from
which you will be viewing your DVDs (armchair,sofa,... symbolised by the cross on the screen).
1. From the player's menu,highlight Test and validate
by pressing OK.
2. In the screen which is displayed, the loudspeaker to
be adjusted is identified for a few seconds by a
colour contour. Use this automatic selection to adjust
the volume of that loudspeaker by increasing or
decreasing the volume of the test signal (background
hiss).
3. Adjust the volume level using the or key.
Note :- 10 dB corresponds to the lowest volume level,and 0 dB is
the highest volume level.First of all,adjust the volume in order to
hear the sound at the same strength from all the loudspeakers.You
may need to readjust these settings after having watched a few
films, to suit to your ownpersonal preferences.
2_DTH720_en 22/06/04 11:26 Page 31