Filter
Top Products
Operating Instructions User's Guide LDK 4502 - HDTV Camera Base Station 3-3
Prod
Prog
Cam +Floor
Eng
Camera Base Station
Camera
Communication
On Air Base
Station
Camera
Connected
Test
HDTV
Front panel
6
7
8
9
1 2 3 4 5 6 7 8 9
1
2
3
4
5
Display
During normal operation the display shows the number of the
camera connected to the Base Station.
When the set-up control (located behind the left front cover)
is activated, the display shows a two letter code to identify the
set-up function (see Set-Up).
The display can be switched on or off via the Base Station
menu system.
Intercom volume control
Adjusts the volume of the selected intercom channel being
monitored on the connector below.
Intercom selection switch
Use this switch to select the intercom channel that is monitored
on the connector below.
Intercom connector
Connect a headset to this connector to monitor the selected
intercom channel.
Camera Communication
This green LED lights when the communications between
Camera and Base Station are OK.
On Air and ISO indicators
The red LED lights when the Camera is On Air.
If the Camera is selected as ISO Camera the yellow LED
lights.
Power Switch
Switches the power supply to the Base Station on and off. A
built-in light lights to indicate that the power is ON.
Base Station
This green LED lights when the Base Station is operationally
ready.
Camera indicators
This bicolour TEST LED lights red or yellow to indicate the
Camera and Triax status:
- Red lights continuously – Triax short circuit.
- Red flashes – Triax open circuit.
- Yellow – Camera power switched off with the
Operational or Master Control Panel.
This green CONNECTED LED lights when the Camera is
connected and the Camera power switch is On.