Filter
Top Products
3-6 User's Guide LDK 4502 - HDTV Camera Base Station Operating Instructions
Making changes
To find out where to change a function, consult the List of
System Menu Functions at the end of this section to find out
under which menu group or subgroup the function is located.
If the cursor points to an item (and there are no double arrows
to indicate a sub-menu) then the item pointed to has a value.
The value can be:
- a toggle value (only two values)
- a list value (more than two values)
- an analogue value (variable from 00 to 99)
or unavailable (---).
If the value is unavailable it cannot be changed. This is
indicated by three dashes (---). This can occur, for example,
when a function is switched off. The analogue values
associated with that function are then unavailable.
If there are only two values associated with the function, then
pressing the Rotary/Push button toggles between these two
values.
If a value is displayed next to a function that is one of several
possible values, then pressing the Rotary/Push button places
the cursor in a list menu indicating the value currently
selected. Use the Rotary/Push button to point to a new value.
Press the Rotary/Push button to return the cursor to the
function list.
If an analogue value is displayed next to a function name,
then pressing the Rotary/Push button places the cursor in
front of the value and the Rotary/Push button is used to
change the analogue value. Press the Rotary/Push button to
return the cursor to the function list.
Undoing changes
If you make changes to the settings in the Systems menu and
you decide not to keep them, use the Recall File function to
recall a standard or stored set of values for the parameters.
These files are available in the FILES menu.
Leaving the Systems Menu
If you are deep within the menu structure, follow these steps
to leave:
a. If necessary move the cursor to the left most column
with the Rotary/Push button.
b. Scroll upwards until the cursor points to TOP (this is
the main menu).
c. Press the Rotary/Push button. The cursor now points
to the Menu off item of the MAIN menu.
d. Press the Rotary/Push button to leave the system
menu.
This is the recommended way of leaving the system menu.
The menu system disappears after a few seconds when you
stop navigating. (This delay can be programmed in the
MONITORING / MENU
menu.) However, when you enter the
system menu again you enter at the last position of the cursor
and not at the top of main menu.
To prevent confusion the next time you enter the system
menu, it is advisable to leave the system menu by returning
to the main menu (TOP) and selecting
MENU OFF
.