Filter
Top Products
8
Listening to Radio
Tuning and Playing the Radio
1. Press the Button to turn the unit on.
2. Move the Function Switch as needed to select AM or FM radio band. The currently tuned
station frequency will appear at the bottom of the display, with FM or AM icon showing the
radio band setting.
3. Turn the Tuning Dial to tune the radio to a desired station.
Extend the FM antenna as far from unit as possible and position for best reception. Do not strip or alter the antenna wire.
The unit has an internal AM antenna. Position the unit as needed for best AM reception.
4. Turn the Volume Dial to adjust the volume.
5. To turn off the unit, press the Button.
Sleep Operation: Bedtime Beats and Radio
Sleep mode lets you sleep to Bedtime Beats or the radio until the T205 shuts off at your selected time.
1. Move the Function Switch as needed to select your sleep source: Sounds for Bedtime
Beats, or select AM or FM radio band. Do not set source to AUX.
2. Press the Sleep Button to enter sleep mode. The Sleep Icon will appear on top of the display to indicate the unit is in
sleep mode. You can adjust the sleep timer from 90, 60, 30,15 minutes or OFF by pressing the Sleep Button as needed.
The unit will automatically turn off after the selected time.
3. When the display changes from the sleep time setting, if you have selected Sound as your sleep source, the currently
selected Bedtime Beat (
bb1 = classical, bb2 = jazz, bb3 = new age, bb4 = selections from beats 1-3) will be displayed.
Press the << or >> Button to cycle to your preferred Bedtime Beat.
During sleep mode, press the Sleep Button once to show the sleep time remaining. Pressing it again will change sleep
time to the next lowest increment.
4. Turn the Volume Dial to adjust the sleep volume. The volume will remain at that level the next time the unit is activated
by alarm or by pressing the Button.
5. To stop listening at any time, press the Button on the T205 to turn the unit off.
Dimmer Operation
During normal operation, press the Snooze/Dimmer Button to control the brightness of the LCD display.