Filter
Top Products
4.1 Searching broadcasting services 31
1. Choose your desired satellite at the Satellite Name op-
tion.
2. Select the tuner that is connected to the motorized an-
tenna at the Tuner Select option.
3. Set the DiSEqC Command Mode to User.
4. Select the Goto option at the Motor Control menu. Then
the antenna will turn toward your selected satellite with
the position data that the digital receiver has.
5. If the receiving quality, which is displayed on the right
bottom on the screen, is not good, tune the antenna finely
with the options of the Movement menu. If you select
the 2(E) movement option, the antenna will move to the
east by two degrees. At this time you had better check
the receiving quality of every transponder and choose
the best one at the Transponder (or Frequency) option.
It will be helpful to your fine tuning.
6. Finally select the Store option at the Motor Control menu
to save the tuned position when the receiving quality
has turned good.
There are more motor control options for installers, but this
manual does not describe them. If you are an installer, refer
them to the manual for the STAB rotor.
4.1.3 Configuring USALS settings
USALS (Universal Satellite Automatic Location System), also
known as DiSEqC 1.3, calculates the positions of all available
satellites from your location. Compared to DiSEqC 1.2, it is
no longer required to manually search and store every satel-
lite position. Just by pointing to a known satellite position is
enough. This position will act as the central point. The USALS
will then calculate positions of visible satellites.