Filter
Top Products
28 Service Search
You can search only services of a specific transponder because
more than one service are provided via one transponder. To
do that, set the Search Mode option to Manual, and then se-
lect your desired transponder at the Channel option. The
transponder number ranges from 5 to 12 in VHF and 21 to 69
in UHF.
To search one service of a transponder, set the Search Mode
option to Advanced, and specify the PIDs of your desired ser-
vice at the PID option with the numeric buttons. PID (Packet
Identifier) is a set of numbers that identifies transport stream
packets.
To start service search, select the Start Search item; then ap-
pears a list box, in which found services will be listed. Press
the
✄
✂
✁
OK button to save found services when it is completed.
To stop at any time, or to exit without saving, press the
✄
✂
✁
EXIT
button.
4.2 Resetting to factory settings
The digital receiver maintains the following data:
• Service list
• Favorite list
• Timer list
• Preference settings
You can reset all data of the digital receiver. If you want to re-
set all the data, select the Installation > Factory Setting menu,
then you are asked for confirmation. If you select Yes, service
entries, favorite entries and timer events will be all deleted,
and preference options will be reset to the manufacturer’s fac-
tory settings.
The digital receiver will ask for your location and language
after resetting all the data. You have to designate them so that
you can perform service search again.