Toshiba 19CV100U Flat Panel Television User Manual


 
22
Chapter 2: Connecting your TV
Connecting a digital audio
system
The TV’s DIGITAL AUDIO OUT terminal
outputs a Dolby
®
* Digital or 2-channel
down-mixed PCM (Pulse-Code Modulation)
signal for use with an external Dolby
®
Digital
decoder or other external audio system with
optical audio input.
If you have a DTS
* decoder or processor, you
can obtain the full benefit of 5.1 channel DTS
encoded soundtracks on DVDs and audio CDs.
You will need:
optical audio cable (Use an optical audio cable
that has the larger “TosLink” connector and not
the smaller “mini-optical” connector.)
To control the audio:
Note:
Some audio systems may not be compatible
with Dolby Digital bitstream signals. Older
audio systems that are not compatible with
standard optical out signals may not work
properly, creating a high noise level that
may damage speakers or headphones.
THIS DAMAGE IS NOT COVERED BY
YOUR WARRANTY.
The DIGITAL AUDIO OUT terminal may not
output some digital audio sources because
of copy restrictions.
* Manufactured under license from Dolby
Laboratories. Dolby and the double-D symbol
are trademarks of Dolby Laboratories.
** M
anufactured under license under U.S. Patent #:
5,451,942 & other U.S. and worldwide patents
issued & pending. DTS and the Symbol are
registered trademarks and DTS Digital Out and
the DTS logos are trademarks of DTS, Inc.
Product includes software. © DTS, Inc. All Rights
Reserved.
1
Turn on the TV and the digital audio device.
2
Press on the remote control and open the
Sound menu.
3
Press or to select Audio Setup and then
press .
4
Press or to select Optical Output
Format.
5
Press or to select either Dolby Digital or
PCM, depending on your device.
( “Selecting the optical audio output format”
on Page 41).
6
To save the new settings, highlight Done and
then press .
To revert to the factory defaults, highlight
Reset and then press .