Filter
Top Products
32
Chapter 5: Setting up your TV
Viewing the digital signal meter
You can view the digital signal meter in the ANT/
CABLE digital TV input source only.
To view the digital signal meter:
Setting the Time Zone
The Time Zone setup will allow you to specify the
correct time zone for your region. This feature will
allow the TV status information to show the
correct time zone information for your viewing
area.
To set the time zone:
After the time zone has been set, you will be asked
to set the current Daylight Saving Time status.
To set the Daylight Saving Time Status:
Viewing the system status
Reset Factory Defaults
To cancel the reset:
Highlight No and then press .
1
From the Setup menu, press or to
select Installation and then press .
2
Press or to highlight Terrestrial, and
press or to select Signal Meter and
then press .
3
Press to select the antenna input
and digital channel whose signal you want to
check.
Note:
• The physical digital channel number
listed in the Signal Meter screen may not
correspond to a virtual TV channel
number. Contact your local
broadcasters to obtain the RF channel
numbers for your local digital stations.
• The signal strength does not change
between virtual channels on the same
physical channel.
1
From the Setup menu, press or to
select Installation and then press .
2
Press or to highlight Terrestrial, and
press or to select Time Zone and then
press .
3
Press and then or to select the region.
4
Highlight Done, and then press .
1
Press or to select Yes or No, highlight
Done, and then press .
1
From the Setup menu, press or to
select Installation and then press .
2
Press or to highlight System Status,
and press or to select System
Information and then press .
3
Press or to scroll through the menu bar to
select Support Information and view the
related information.
1
From the Setup menu, press or to
select Installation and then press .
2
Press or to highlight System Status,
and press or to select System
Information and then press .
3
Press or to scroll through the menu bar to
select Factory Defaults.
4
Enter your PIN code (or 0000 if no PIN code
has been set).
5
Highlight Yes and then press . The TV will
turn off automatically after a few seconds.
After the TV turns off, unplug the TV power
cord and then plug it in again to complete the
reset process.