Filter
Top Products
20
Connecting an amplifier equipped with a
digital audio input
2 channel digital stereo
You can enjoy the dynamic sound of 2 channel digital stereo by
connecting an amplifier equipped with a digital audio input and speaker
system (right and left front speakers).
Connecting a PC (Personal Computer)
Before you connect this TV/DVD to your PC, change the adjustment of
your PC’s Resolution and Refresh rate. See “Monitor Display modes”
at right.
Connect one end of a (male to male) VGA cable to the video card of
the computer and the other end to the VGA connector PC at the back
of the TV/DVD. Fix the connectors firmly with the screws on
the plug. In case of a Multimedia computer, connect the audio cables
to the audio outputs of your Multimedia computer and to the AUDIO L
and R connectors of the PC IN jacks of the TV/DVD.
Press INPUT and number button 5 on the remote control to select PC
mode.
Switch on the computer. The TV/DVD can be operated as the
computer monitor.
Monitor Display modes
MODE Resolution Refresh rate
VGA 640x480 60Hz
SVGA 800x600 56.3Hz
SVGA 800x600 60.3Hz
XGA 1024x768 60Hz
Rear lower right of TV/DVD
Amplifier equipped with a
Digital audio input
To COAXIAL
type digital
audio input
To COAXIAL
DIGITAL AUDIO
OUT
Rear lower right of TV/DVD
You will need:
• one VGA cable
To PC
You will need:
• one coaxial cable
Notes:
• PCM audio is limited to DVD or CD
playback.
• Connect the COAXIAL DIGITAL AUDIO
OUT jack of the TV/DVD to the “COAXIAL”
input of a Receiver or Processor.
• Refer to the owner’s manual of the
connected equipment as well.
• The output sound of the TV/DVD has a wide
dynamic range. Be sure to adjust the
receiver’s volume to a moderate listening
level. Otherwise, the speakers may be
damaged by a sudden high volume sound.
• Turn off the amplifier before you connect or
disconnect the TV/DVD’s power cord. If you
leave the amplifier power on, the speakers
may be damaged.
To return to TV mode:
Press INPUT again.
Notes:
• The current signal source does not display
when you return to TV mode.
• The form of a character of OSD in PC mode
differ from TV or DVD mode.
Connecting
your TV/DVD
J5P00101A(E)P11-21 8/12/04, 11:24 AM20