Filter
Top Products
28
Set up
Preparation
Basic Operation
Advanced Operaion
Reference Section
Using V-CHIP Control
Some TV programs and movies include signals that classify the content of the program (violence, sex, dialog, language).
The V-CHIP Control feature in this TV detects the signals and blocks the programs according to your selections.
To use this feature, perform the following setup.
Selecting the V-CHIP CONTROL menu
1 Press MENU then s or t repeatedly until
“V-CHIP CONTROL” in the Set up menu
is displayed in purple.
To return to the normal picture
Press EXIT.
2 Press T or S to display the pin code
entering mode.
●
Factory reset status
Set your 4 digit code by pressing the
Number buttons (0-9).
Example:To enter “1110”
Press 1, 1, 1, and 0 in order.
●
When the pin code is already stored
Press the Number buttons (0-9) to
enter the 4-digit pin code used to
block channels.
TIMER:
TV/CABLE:
CH PROGRAM
ADD/ERASE:
V-CHIP CONTROL
0 MIN
[TV]CABLE
[ADD]ERASE
FAVORITE CH
MOVE[
t s
] START[
T
S
]
If a wrong pin code has been entered
This message will appear. Try to enter
the correct code again.
If you can not remember the pin code you
have stored, while in the pin code entering
mode, press the RECALL button four
times within 5 seconds.
The pin code you have stored will be
released. (Factory reset status).
ENABLE BLOCKING : Y[N]
SET RATING
SET BLOCKING OPTIONS
NEW PIN CODE
BLOCK CHANNEL
MOVE[t s ] SELECT[T S ]
3 After about 1 second, the screen changes
to the V-CHIP CONTROL menu as
shown.
Continue to set each item following the steps
on the next page.
INCORRECT PIN CODE
PLEASE ENTER PIN CODE
1235
SELECT[0-9] END[EXIT]
BLOCKING IS ACTIVE
PLEASE ENTER PIN CODE
1234
SELECT[0-9] END[EXIT]
TV
CABLE
VCR
MENU/
ENTER
CH RTN
RECALL MUTE
CH
CH
VOL VOL
1
4
7
2
5
8
3
6
9
0
ENT
100
POWER
o
REWPAUSE
FF
SOURCESTILL
PIP
SLOW
PIP CH LOCATE SWAP
STOP
PLAY
REC
TV/VCR
TV/VIDEOFAV CH
A
EXIT
T S
s t
Number
buttons
EXIT
MENU
RECALL
BLOCKING IS RESET
PLEASE ENTER NEW PIN CODE
1110
SELECT[0-9] END[EXIT]