Filter
Top Products
34
Set up
Preparation
Basic Operation
Advanced Operaion
Reference Section
Before Calling Service Personnel
Problem Checks and Adjustments Page
TV will not turn on
●
Make sure the power cord is plugged in, then press POWER button. 15
●
Check battery in the Remote. (Maybe batteries are “dead”.) 8
No picture, no sound
●
Check antenna/cable connections. 5
No sound, picture OK
●
Maybe sound is muted. Try pressing VOLUME S button. 15
●
Try another channel. (Maybe station trouble.)
Poor sound, picture OK
●
Try another channel. (Maybe station trouble or local interference
from appliance.)
Poor picture, sound OK
●
Check antenna/cable connections.
●
Try another channel. (Maybe station trouble or local interference.)
●
Adjust Picture menu. 20
Poor reception of broadcast channels
●
Try another channel.
●
Check antenna connections. 5
●
If using VCR, check TV/VCR button. 10
No UHF, VHF OK
●
Make sure TV/CABLE function is in “TV” mode. 16
Black box appears on the screen
●
Captioning may be turned on 27
Cannot select a certain channel
●
That channel may be locked out with BLOCK CHANNEL function, or 31
erased with the ADD/ERASE function. 17
Multiple images (ghosts)
●
Try another channel. (Maybe station trouble.)
●
Use a highly directional outdoor antenna.
Poor color or no color
●
Try another channel. (Maybe station trouble or local interference.)
●
Adjust TINT and/or COLOR in the Picture menu. 20
●
If you change the direction of the TV while the TV is activated, the
picture may suffer from color shading. If so, turn off the TV and allow
it to cool for about 30 minutes, then turn on the TV again.
The picture should improve.
No stereo or SAP sound from an MTS
●
Check if MTS function is properly set. 22
broadcast
The Remote Control does not operate
●
Check if TV/CABLE/VCR switch is properly set. 9, 10
●
Maybe something was between the Remote and the remote sensor.
●
Maybe batteries are dead. Try replacing batteries with new ones. 8
Before calling service personnel, please check the following chart for a possible cause of the problem you are experiencing. A
minor adjustment on your part may eliminate the problem and restore your TV reception.