Filter
Top Products
Input selection and AV connections
17
Defining the INPUT and OUTPUT sockets so that the television recognises connected equipment. See page 6
for a clear view of the back connection recommendations.
Select AV connection.
Use
S
or
R
to change the EXT3 output option to:
Monitor = The picture on screen.
TV = The last television programme selection.
EXT1 = The picture from equipment connected to
SCART 1.
EXT2 = The picture from equipment connected to
SCART 2.
EXT4 = The picture from equipment connected to
the front/side input sockets.
This enables selection of the source to output from
SCART 3. For example, to record transmissions in stereo
from a stereo decoder – connect a stereo decoder to
SCART 1 and stereo VCR to SCART 3, then select EXT 1
as the EXT3 output. The signal received through
SCART 1 will output directly through SCART 3.
Most VCRs and decoders send a signal through the SCART
lead to switch the television to the correct Input socket.
Alternatively press the external source selection button
B
until the picture from connected equipment is shown.
An S in the display e.g.
B
3S (EXT 3S), indicates the
input is set for an S-Video signal.
Press
B
to select
B
1,
B
2,
B
3, or
B
4
(EXT 1-4).
To return totelevision mode press
B
again or
one of the numbered buttons.
Use the Input Selection if the television does not switch
over automatically.
Input selection
OUTPUT signal selection for SCART 3
1
This specifies the type of signal going into SCART 3 (EXT3)
on the back of the television. Please refer to the
manufacturers instructions for the connected equipment.
In the SET UP menu press
Q
until
AV connection is highlighted, then press
R
.
With
S
or
R
select either AV or S-VIDEO as the
required input for EXT3.
If the colour is missing try the alternative setting.
INPUT signal selection
1
1
2
2
▼▼▼▼
▼ ▼▼
EXT3 input AV
EXT3 output EXT1
Woofer Int.
Audio output Fixed
AV connection
EXIT :To exit
▼
▼▼▼▼
▼ ▼▼
EXT3 input AV
EXT3 output EXT1
Woofer Int.
Audio output Fixed
AV connection
EXIT :To exit
▼