Filter
Top Products
Colour : Auto.
EXT 2 A DVD
Manual setting
OK : To store
MENU : To return
EXIT : To exit
A
Remove it by pressing CALL.
Why is there a message permanently on the
screen?
Q
A
Check the side switch on the remote control is in
television mode.
Check the batteries aren’t dead or inserted incorrectly.
Why doesn’t the remote control work?
Q
A
Check that Panel lock is not ON.
Why don’t the controls on the side/front of the
television work?
Q
A
Check the correct input has been chosen,
S-VIDEO or AV. See AV connection.
Why is the VCR/DVD picture in black and
white?
Q
A
Interference or a weak signal. Try a different
television station. Manual fine tuning may help.
What else can cause a poor picture?
Q
Below are the answers to some of the most common queries.
For more information go to www.toshiba.co.uk
A
Check the mains switch is on and check all
connections.
Check the television is not in standby mode.
Why is there no sound or picture?
Q
A
Check the volume has not been turned down or
that sound mute has not been selected.
Why is there a picture but no sound?
Q
A
Check the SCART lead connection.
Why is there a good video picture but no sound?
Q
A
Make sure the VCR or DVD player is connected to
the television as shown on page 6, then select the
correct input by pressing
B
.
Why doesn’t the video/DVD being played show
on screen?
Q
?
For television
operation queries,
please ring the
helpline…
Remember…
Questions and Answers
20
A
This is sometimes due to condensation if the room
temperature rises rapidly or the television is moved
from a cold room to a warm room. Leave the television
turned on for a while this should improve the images.
Why are there distorted images/faded colours?
Q
A
When using an external source, for instance, a
poor quality video tape, if there is little or no
colour, improvements may sometimes be achieved. The
colour is factory set to Auto. to automatically display the
best colour system.
To check that you have the best colour:
There is a picture, but why is there little or no
colour?
Q
With the external source playing, select Manual
setting from the SET UP menu.
With
S
or
R
choose between Auto., PAL,
SECAM, NTSC 4. 43 or 3. 58.
1
2
▼
▼