Filter
Top Products
N
N
O
N
Y
O
N
Y
SETTING UP
7
Connecting and turning on your new TV
The TV back connections…
To conserve energy it is best to turn your TV off and not to leave it in Standby, unless the timer has
been set.
Connect the aerial to the socket on the rear of the television. If you use a Set Top Box and/or a video recorder it is
essential that the aerial cable is connected through the Set Top Box and/or through the video recorder to the television.
DO NOT CONNECT SCART LEADS UNTIL THE TELEVISION IS FULLY TUNED.
RED = Power On
GREEN = On Timer is set
GREEN = Stereo transmission
being received
ORANGE = Bilingual transmission
being received
DIGITAL AUDIO INPUT
PCM/DOLBY DIGITAL
OPTICAL COAXIAL
DIGITAL AUDIO INPUT
PCM/DOLBY DIGITAL
OPTICAL COAXIAL
the back of your TV
…and switching your new TV on…
AERIAL
VIDEO RECORDER
SET TOP BOX*
AERIAL CABLE
AERIAL CABLE
*
a SET TOP BOX could be:
Digital Satellite, Analogue
Satellite, or any other
compatible decoder.
☛
On the front of the TV…
If the red power-on light is unlit, press the POWER button on the front of the
TV to switch the set on and then press a number button on the remote
control to see the screen.
…and with the remote control:
Press the Standby Button
i
:
This allows you to put the set
into standby mode when leaving
the TV unattended for short
periods of time. To return to TV
mode press the
i
button, or any
of the numbered buttons on
the remote control. The picture
may take a few seconds to appear.