PAGE 23
1. Refer to pages 10-16 to connect external equipment to your TV. If you have done so, plug
in your TV to a standard (non-switched) 120V 60Hz power outlet.
2. If you have done so, remove the back of the remote and install in two AA batteries. Make
sure batteries are properly installed (check the +/– symbols).
3. With the remote control in hand, press the POWER button to turn your TV on.
- Redo Auto Program if the DLP projection TV is ever moved to
another location.
- Auto Program will search for channels only through the ANT IN
jack.
- If channels numbers for broadcast over-the air TV and cable TV are
duplicated where different channels have the same number, press
the same number buttons again to toggle between:
(For example, press 17 to go to the channel, press 17 again to go
to the duplicated channel.)
CHANNEL
PICTURE
AUDIO
TIMER
SPECIAL
SCREEN
PIP/DW
LOCK
Prev.
Menu
To start
Auto program G
Manual program
Surf list
4.Press the MENU button and then use
D / E
button to select the
CHANNEL menu.
5.Press the
G button and then use
D / E
button to select Auto
program
.
6.Press ENTER or the
G button to start Auto program channel
search.
If you want to stop auto programming, press the ENTER but-
ton. Only the channels found up to at that time are memo-
rized.
Broadcast TV Channels
Cable TV Channels
Turning the TV On
Caution: Never throw batteries into a fire.
