Filter
Top Products
PAGE 22
How to use
1. Connect the HDMI Source Devices(DVD Player or Set Top Box or PC) and the set.
2. Turn on the display by pressing the POWER button on the set and HDMI Source Devices remote control.
3. Select HDMI Input source in Main Input option of PIP/DW menu.
4. Check the image on your set. There may be noise associated with the resolution, vertical pattern, contrast or
brightness in HDMI Source Devices. If noise is present, change the HDMI Source Devices to another resolution,
change the refresh rate or adjust the brightness and contrast on the menu until the picture is clear. If the refresh
rate of the PC graphics card can not changed, change the PC graphics card or consult the manufacturer of the PC
graphics card.
Notes:
- Depending on the graphics card, DOS mode may not work if you use a HDMI to DVI Cable.
- Avoid keeping a fixed image on the set screen for a long period of time. The fixed image may become permanent-
ly imprinted on the screen. Use the Orbiter screen saver when possible.
- When Source Devices connected HDMI Input, output PC Resolution(VGA, SVGA, XGA), Position, Size may not fit to
Screen. As shown the lower picture, press the MENU button to adjust the screen Position of the set and contact an
PC graphics card service center.
- When Source Devices connected HDMI Input output the set Resolution(480p, 720p, 1080i), the set Display fit
EIA/CEA-861-B Specification to Screen. If not, refer to the Manual of HDMI Source Devices or contact your service
center.
- In case HDMI Source Devices is not connected Cable or poor cable connection, "No Signal" OSD display in HDMI
Input. And In case of Video Resolution not supported the set output in HDMI Source Devices, "No Signal" OSD dis-
play. Refer to the Manual of HDMI Source Devices or contact your service center.
Référence
Échantillon de câble
Câble HDMI à DVI
(non fourni)
Câble audio analogique
(type RCA) (non fourni)
Câble audio analogique (stéréo à type RCA)
(non fourni)
Câble HDMI
(non fourni)