Toshiba BDX4300KU Blu-ray Player User Manual


 
15
Remote control buttons
5.375 x 8.375 ver 3.1
Do not mix different battery types or combine used batteries with new ones.
If the remote control does not operate correctly, or if the operating range is reduced, replace
both batteries with new ones.
If the batteries are dead or if you will not be using the remote control for a long time, remove
the batteries to prevent battery acid from leaking into the battery compartment.
Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
When discarding batteries, environmental problems must be considered and local rules or
laws governing the disposal of these batteries must be strictly followed.
Using the remote control
Point the remote control at the remote sensor and press the buttons:
(Sample Illustration) Remote control angle
Distance: Approximately 5m from the front of the remote sensor.
Angle: About 30° in each direction from the front of the remote sensor.
Do not expose the remote sensor to a strong light source such as direct sunlight or other
illumination. This can damage the sensor resulting in the inability to operate the Blu-ray
Disc™/DVD player via the remote control.
Do not drop or expose the remote control to electric shock.
Do not expose the remote control excessively hot or humid places.
Do not spill water or place anything wet on the remote control.
Do not open the remote control.
If the remote control is not going to be used for a long period of time, remove the battery to
avoid damage caused by battery leakage corrosion.
Direct the remote control at the remote sensor of the Blu-ray Disc™/DVD player.
When using the remote control, press the buttons at intervals of approximately 1 second to
ensure the correct mode of operation.