Filter
Top Products
Introduction
Connecting
your TV
Using the
Remote Control
Setting up
your TV
Using the TV’s
Features
Appendix
Index
14
(E) 46HM84 52HM84 62HM84
Connecting two VCRs
This connection allows you to record (dub/edit) from one VCR to
another VCR while watching a videotape. You also can record from
one TV channel while watching another TV channel.
You will need:
• two coaxial cables
• two sets of standard A/V cables
IN from ANT OUT to TV
CH 3
CH 4
VIDEO
AUDIO
LR
IN
OUT
VIDEO AUDIO
CH 3
LR
CH 4
IN
OUT
Connecting a camcorder
This connection allows you to watch video materials recorded on a
camcorder.
You will need:
• one set of standard A/V cables
VIDEO
AUDIO
OUT
L
R
**
Note:
If you have VCRs with S-video, use S-video
cables instead of standard video cables for
better picture performance. Do not connect
both a standard video cable and an S-video
cable to Video-1 (or Video-2) at the same
time, or the picture performance will be
unacceptable.
Do not connect the same VCR to the output
and input jacks on the TV at the same time.
To dub or edit, VCR 2 must select Line IN,
and the TV must select VIDEO 1 (see
“Selecting the antenna input” on page 23).
*The VIDEO OUT jack does not output the
POP picture.
** The AUDIO OUT jacks can output the
sound of either the Main or POP picture
(see “Selecting the Audio OUT sound” on
page 54).
VCR1
From
Antenna
TV
VCR2
*
Note:
If you have a camcorder with S-video, use an
S-video cable instead of a standard video
cable for better picture performance. Do not
connect both a standard video cable and an
S-video cable at the same time, or the picture
performance will be unacceptable.
The unauthorized recording, use,
distribution, or revision of television
programs, videotapes, DVDs, and other
materials is prohibited under the
Copyright Laws of the United States and
other countries, and may subject you to
civil and criminal liability.
Camcorder
Video-3 (side panel)
46,52,62HM84(E)08-16 6/21/04, 9:56 AM14