Filter
Top Products
24
TURNING ON THE DVR
Once the cables and adapters have been properly connected it is time to turn on the power. To turn on the power follow these steps:
4. Turn on the monitor and any external peripherals (ex. Printers, External Storage Devices, etc.) connected to the DVR.
5. Turn on the Secondary Power Switch located in the rear of the DVR.
6. Turn on the main power switch located on the front of the DVR.
The DVR will run a series of self-tests. After two or three minutes a series of messages may be displayed as the various hardware and
software subsystems are activated. Under normal circumstances you should not be asked to respond to these messages. If you are
asked to respond to the messages (adding a Printer, Monitor, etc for the first time) follow the instructions carefully.
After this finishes, the Surveillix DVR software should load automatically and bring you to the main screen.
TURNING OFF THE DVR
To turn off the DVR unit, select the Exit button on the main screen and select Power Off. The DVR will safely shutdown, it may take
several minutes to shut down completely.
CAUTION: Always be sure to follow the proper procedures when turning off the power to the DVR. NEVER disconnect
the power to the DVR while it is still running or in the process of shutting down. Doing so can cause data loss, file
corruption, system instability and hardware failure