Filter
Top Products
the 2 self tapping screws on the back panel.
7. Remove the top portion of the shield and set
it aside.
8. Unclip the wires leading to the power supply.
9. Lift the main board and remove the bottom
portion of the shield. Then rest the main
board in the built-in holders.
10. Align the notch in the board with the bottom
of the built-in holder to avoid damaging the
main board.
11. Before unplugging the flex cables, the laser
pickup must be shorted to prevent static
damage to the laser.
12. To access the laser pc board, remove the
safety shield covering the laser assembly.
13. Remove the 2 screws holding the disc clamp
and lift it off the laser assembly.
14. Cut the cable tie that holds the power supply
cable to the cross bracket.
15. Remove the 2 screws holding the cross bar
and lift the cross bar off the player.
16. Remove the 2 screws holding the disc tray in
the player.
17. Pull the tray out of the player.
18. Carefully solder the pad with a small tipped
soldering iron.
19. Remove the main board by gently unplugging
the flex cables and the power supply connec-
tor.
20. Lift the main board out of the holders.
21. Remove the 4 screws holding the power
supply.
22. Lift the power supply board out of the cabi-
net.
23. Remove the 3 screws holding the laser me-
chanical assembly.
24. Lift the assembly out of the cabinet.
25. Remove the component video output board by
retracting 2 screws on the back of the cabinet.
26. Remove the front panel by retract 4 screws, 1
on each side and 2 on the top.
27. Releasing the tabs and pull the panel away
from the cabinet.
28. The front panel circuit boards are remove by
retracting 6 screws,.and lifting the circuit
boards out of the front panel.
LASER DISASSEMBLY
1. Unplug the flex cable attached to the laser
slide assembly.
2. Remove the 4 screws and washers holding the
laser slide assembly in place.
3. Lift the laser slide assembly out and set it
aside.
4. Retract 2 screws at the rear of the mechanical
assembly.
5. Remove the lift assembly.
6. Remove the loading motor by first taking off
the loading belt.
23