Filter
Top Products
28
Connecting to a TV equipped with component video inputs
If your TV has component video inputs, you can obtain pictures in better quality than via standard
composite video input.
Connections
• Make the following setting.
On-screen display
Select
Page
“Audio out select” page 46
Component video outputs/inputs
Some TVs or monitors are equipped with component
video inputs. Connecting to these inputs allows you to
enjoy higher quality picture playback.
Actual labels for component video inputs may vary
depending on the TV manufacturer. (ex.Y, R-Y, R-B or
Y, C
B, CR)
In some TVs or monitors, the color levels of the
playback picture may be reduced slightly or the tint
may change. In such a case, adjust the TV or monitor
for optimum performance.
Notes
• Refer to the owner’s manual for the TV to be connected to this recorder for more information concerning an audio system.
• If you place the recorder near a tuner or radio, the radio broadcast sound might be distorted. In this case, place the recorder
away from the tuner and radio.
• The output sound of the recorder has a wide dynamic range. Be sure to adjust the audio amplifier’s volume to a moderate
listening level. Otherwise, the speakers and your hearing may be damaged by sudden high volume sound.
• Turn off the amplifier before you connect or disconnect the recorder’s power cord. If you leave the amplifier power on, the
speakers may be damaged.
• Consumers should note that not all high definition television sets are fully compatible with this product and may cause
artifacts to be displayed in the picture. In case of 525 progressive scan picture problems, it is recommended that the user
switch the connection to the “Standard Definition” output. If there are questions regarding our TV set compatibility with this
model 525p DVD player, please contact our Customer Service Center.
To COMPONENT OUTPUT PR
To COMPONENT OUTPUT PB
To COMPONENT OUTPUT Y
To Y video input
To P
B video input
To P
R video input
TV or monitor equipped with
component video (INTERLACED/
PROGRESSIVE) inputs
Video cable
(not supplied)
“Analog 2ch”
To switch the output signal (Progressive/Interlaced)
Press PROG/HDMI button to change the
video output signals (progressive and
interlace) from COMPONENT OUTPUT jacks.
Only video signals are output
from the COMPONENT OUTPUT
jacks.
(Audio signals are not output.)
To obtain the sound, connect an
audio system to the audio output
terminals.
Press
off 480i
illuminates 480p
illuminates 480p
illuminates 480p
PROGRESSIVE indicator
on the front panel
Output signal from the
COMPONENT OUTPUT jacks
Press
Press
You may need to press the PROG/HDMI button up
to 3 times to return to interlace output.
RD-XS55SU_Inst_E_p19-30 06.3.20, 3:14 PM28