Filter
Top Products
40
Function setup
Multi brand remote control
The remote control can be compatible with various brands of TV by
setting their control codes. The TOSHIBA code has initially been set
to control TOSHIBA TVs.
Setting TV control codes
Press TV to set the remote control operating
your TV.
1
2
Important
Some TV’s may not respond to all the operations left, or
may not be operated at all with this remote control. In
this case, operate your TV with its own remote control.
Notes:
• For some brands, several control codes (brand codes) are al-
located. Try each of them until the buttons work on your TV.
• If you replace the remote control’s batteries, set the brand code
again.
Table of TV brand codes
Brand No. TV Brand Brand No. TV Brand Brand No. TV Brand
01 TOSHIBA 07 PANASONIC 13 SHARP (old)
02 RCA / GE 08 SHARP (New) 14 ZENITH
03 SONY 09 SANYO (FISHER) 15 PANASONIC
04 MITSUBISHI 10 MAGNAVOX 16 PIONEER
05 JVC 11 GOLDSTAR
06 HITACHI 12 SAMSUNG
0–9
PROGRAM
POWER
INPUT SELECT
100
DISPLAY
ENTER
CH+/–, VOL+/–
While holding down PROGRAM enter the two
digits of your TV's brand code (listed below)
using number buttons (0–9), then elease
PROGRAM.
Point the remote control at your TV and use each
button listed berow to make sure that your TV is
operated correctly.
POWER To turn the TV on or off.
CH +/– To select TV channels in the upper
or lower direction.
VOL +/– To adjust the sound level.
INPUT SELECT To select an external source such
as a VCR.
Number buttons To select TV channels. When select-
ing channels 1 to 9, first enter 0 and
then desired number.
100 To substitute for 100 channel key.
DISPLAY To turn on or off TV’s screen dis-
play.
ENTER To use for the TV’s ENTER key.
(0–9)
2C01501A P38-41 12/16/03, 19:5940